Solare-datensysteme Solar-Log Manual de usuario Pagina 268

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 311
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 267
268
Sunpower
Sunpower SPR-M-Model connect with original SMA RS485 piggy back and the SMARS485 data module
Procedure
1. Pull the wire in the inverter through the insulation sleeve attached to the piggy back
The wire must be enclosed in the insulating hose inside the inverter.
2. Connect all 4 contacts (2, 3, 5, 7) on the terminal strip of inverter 1 to inverter 2
Note
A diagram for wiring in SMA combined mode can be found in the appendix.
3. Connect the other inverters to each other in the same way.
4. Terminate in the last inverter.
Put the supplied jumper onto the lower pins on the connector strip.
Figure 5: Jumper SMA
5. Close inverters.
Vista de pagina 267
1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 310 311

Comentarios a estos manuales

Sin comentarios