
188
Reverberi
Reverberi (EDI Series)
66 Reverberi
66�1 Reverberi (EDI Series)
Easy Installation Termination Addressing Interface
No Yes Yes
RS485
Overview
•
Integrated interface
•
Where to connect: Terminal strip inside the inverter
•
2-pin wiring
•
Communication address must be allocated.
•
Installation steps
• Switch off the inverters and Solar-Log™
• Connect inverters to the Solar-Log™
• Allocate communication address
• Terminate inverter
Connect inverters to the Solar-Log™
The wiring is done using a
•
ready-made data cable (optional extra; not supplied)
Procedure:
•
Open the inverter as shown in the inverter's instructions.
•
Pull the free wires through the wire opening in the inverter.
•
If you are making the cable yourself, connect the wires as shown in the following diagram
Solar-Log™ terminal strip connector Terminal strip inverter
Terminal PIN
► 1
5
► 1
7
► 4
4
► 4
6
•
If only one inverter is to be connected this must be terminated.
•
Close the inverter if no other inverters are to be connected.
•
Insert the terminal block connector into the Solar-Log™ RS485 socket.
Connect the inverters to each other
•
Where to connect: Terminal strip inside the inverter
•
2-pin wiring
Comentarios a estos manuales