Solare-datensysteme Solar-Log Manual de usuario descargar pdf (Pagina 52)

Operating via a web browser within your own network

Value specification from:

This field indications how the control value used was determined.

Displayed Text Explanation

Tex t

PMV_NONE No control source.

PMV_CONFIG Thevalueisstoredintheconguration.

PMV_MODE The value can be determined by the reduction mode.

PMV_PR_PIGGY The value comes from the PM (power reduction) input

(andisdeterminedincombinationwiththematrixinthecong-

urationorPMprole).

PMV_MPR_PIGGY The value comes from the PM (power reduction) input of the

master (and is determined in combination with the matrix in the

congurationorPMprole).

PMV_MODBUS_1 The value comes from the ModBus PM V1 interface.

PMV_MODBUS_2 The value comes from the ModBus PM V2 interface.

PMV_PROFILE_ADAM The value comes from the analog or digital input of the IO Box

(Adam Box).

PMV_PROFILE_INTERN ThevalueisspeciedinthePMprole.

PMV_ERROR An error occurred while determining the value.

PMV_CONFIG_UTILITY Thevaluewasdeterminedviatheinternalcongurationbased

the Utility Meter measurement.

PMV_MODBUS_DM The value comes from the ModBus DM interface (direct seller

interface).

Target power output %:

The fields indicates the percentage of the Plant's DC power determined by the control for the target out-

put.

The detailed values for the individual bus connections and for the total plant are displayed in the following

table below. The individual buses (RS485 A-C) are displayed depending on which bus is assigned to con-

trol the inverters.

The column

Total always corresponds to the plant total and reflects the value from the grid connection

point. The consumption values are displayed in all of the columns, but only the plant total is taken into

account.

Note!

The values from the individual inverters are calculated per bus and for the entire

plant.

Generator power (kW):

The generator power corresponds to the module output of the inverter that is connected to this data bus.

This value results from the total of the partial outputs entered in the field generator power under config-

uration | Devices | Configuration. This kW values is used when calculating the output reduction (e.g.: the

70% reduction).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 172 173

Comentarios a estos manuales

Sin comentarios

Solare-datensysteme Solar-Log Manual de usuario Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios para el aire Solare-datensysteme Solar-Log

Prodotti e manuali riguardandi no Aeg-Electrolux A85230GT